News

PLC (Programmable Logic Controller) Selection I/O Point Estimation: First, consider the input and output points of the control object. In food and beverage production, such as a simple beverage filling production line, it may be necessary to control the start and stop of the conveyor belt motor (output point), the bottle detection sensor (input point), […]

Precise control of production processes In food and beverage production, the PLC control cabinet can accurately control the operating parameters of various production equipment. For example, in the beverage mixing link, it can accurately control the amount and time of adding different raw materials. Through precise metering pump control, juice, syrup, additives, etc. can be

Hardware connection Signal input: First, connect the control signal to the input port of the PLC control cabinet. If you need to manually control the start and stop of the fan, you can connect a push button switch. For example, connect the start button and the stop button to the digital input point of the

The following are common faults and solutions for PLC-controlled fans in control cabinets: Input signal failure Failure phenomenon: PLC cannot receive the correct start, stop or sensor input signals. Possible causes and solutions: Button or sensor damage: Check whether the mechanical structure of the button is normal and the contacts are good. For the sensor,

Motor control and protection In chemical production, there are a large number of motor-driven equipment, such as pumps, compressors, mixers, etc. Low-voltage control cabinets can accurately control the start, stop, forward and reverse rotation and speed regulation of these motors. For example, through the application of soft starters or frequency converters in low-voltage control cabinets,

Abnormally high temperature of heat sink Dust accumulation: If there is a lot of dust on the surface of the heat sink, it will hinder the dissipation of heat. Because dust has poor thermal conductivity, it will form an insulation layer on the surface of the heat sink. You can judge by observing whether there

When cleaning the heat sink and vents inside the PLC control cabinet, pay special attention to the following points: Preparation: Before cleaning, make sure the PLC control cabinet is powered off and wait for a while to allow the heat inside the device to dissipate to avoid burns. At the same time, prepare necessary cleaning

Appearance inspection Doors and vents: Check regularly whether the doors can be closed and sealed properly, and make sure that the vents are not blocked. Good ventilation can prevent the temperature in the control cabinet from being too high. For example, check once a month whether the hinges of the cabinet doors are flexible and

Here are some effective ways to avoid PLC failure: Temperature control The ideal operating temperature of PLC is generally between 0-55℃. PLC should be installed in a control cabinet with air conditioning or good ventilation conditions to avoid direct sunlight. For high temperature environments, you can install a radiator or air conditioning system to reduce

The PLC fault indicator light ERR usually lights up, indicating that the PLC has an error or fault. The following are some common specific meanings:Program error:Syntax error: There are places in the written PLC program that violate the syntax rules of the programming language, such as misspelling of instructions, incorrect parameter settings, missing necessary punctuation