News

Abnormally high temperature of heat sink Dust accumulation: If there is a lot of dust on the surface of the heat sink, it will hinder the dissipation of heat. Because dust has poor thermal conductivity, it will form an insulation layer on the surface of the heat sink. You can judge by observing whether there

When cleaning the heat sink and vents inside the PLC control cabinet, pay special attention to the following points: Preparation: Before cleaning, make sure the PLC control cabinet is powered off and wait for a while to allow the heat inside the device to dissipate to avoid burns. At the same time, prepare necessary cleaning

Appearance inspection Doors and vents: Check regularly whether the doors can be closed and sealed properly, and make sure that the vents are not blocked. Good ventilation can prevent the temperature in the control cabinet from being too high. For example, check once a month whether the hinges of the cabinet doors are flexible and

Here are some effective ways to avoid PLC failure: Temperature control The ideal operating temperature of PLC is generally between 0-55℃. PLC should be installed in a control cabinet with air conditioning or good ventilation conditions to avoid direct sunlight. For high temperature environments, you can install a radiator or air conditioning system to reduce

The PLC fault indicator light ERR usually lights up, indicating that the PLC has an error or fault. The following are some common specific meanings:Program error:Syntax error: There are places in the written PLC program that violate the syntax rules of the programming language, such as misspelling of instructions, incorrect parameter settings, missing necessary punctuation

Power supply components Air switch Observation method: Check the position of the switch. Normally, it should be in the “ON” (closed) state. If it is in the “OFF” (disconnected) state, it may be overloaded, short-circuited, or the circuit is manually cut off. At the same time, check the handle of the switch. If there is

The following is an introduction to the common components in the PLC power distribution cabinet: Circuit breaker Function: Mainly used to protect the circuit. When a short circuit, overload or leakage occurs in the circuit, causing the current to exceed the rated current, the circuit breaker will automatically cut off the circuit to protect the

Motor failure Failure phenomenon: The motor cannot start, the motor overheats, and there is abnormal vibration or noise when the motor is running. Failure to start may be due to power supply problems, driver failure or motor failure; motor overheating may be due to excessive load, poor heat dissipation or motor winding short circuit; abnormal

Analyze control requirements Determine the type of control task If it is a simple logic control and sequential control, such as the selection of goods, payment change and shipping process of a vending machine, or the start-stop sequence control of equipment in a factory production line, then PLC control is mainly considered. PLC can easily

Safety Risk of faulty operation: If the normally closed point is used for access, when the line connected to the emergency stop button is broken or loose, the PLC will receive a signal loss, that is, it will mistakenly think that the emergency stop button is pressed. This may cause the equipment to stop suddenly